knitting cable hat

First, a bit about the materials:
- Yarn - Illaria FILOMENA 75% Kid Mohair, 10% Merino wool, 10% polyamide (130m / 50 gr.) - 100 grams
I understand that the yarn is a rare, expensive, so of course it can be replaced by any of the alternatives. Ideally, use a mohair pushistenky or take the main thread and connect with mohair yarn. a yarn parameters - 240-260m / 100g  . You can completely smooth yarn used, there could be a matter of taste))
- Circular knitting needles and №3,5 №4,5 (or other dimensions in the difference in the number)
- Extras. knitting needles bundles and braid. - Tag number
Always advise - do not be lazy, before knitting the front embroidery pattern tie, calculate the density of knitting!  My approximate density - 19 loops of 10 cm. Description I am giving to its density, the size of finished hats - 55-58  We begin with gum. Take the spokes 3.5.
Pattern gum will "gum 2x3" (2 facial, backstitches 3), first knit this pattern to the desired height on the lapel.
To do this, according to my knitting density, I dial 111 loops.
1st row - remove the first loop. Knit pattern gum "2x3" all hinges, the last loop knit together with the first loop is removed on the left spoke - wrong -. It will provide a minimum visibility range of the joint space.
Knitting is closed in a circle. The total number of loops - 110. In the joint between the number you want to place the marker. Next, knitting continues around the circle only the face of the articles.
I knit all 30 rows.  If you want a wide lapel and at the same time a little bit sticking makushechku, then knit 5-10 more rows. In my version of the mature head hat sticks out over the top just a couple of cm, while adjusting the width of the flap and the cap can be done as long-short.
Next, a bit tricky:The transition to a pattern of wire harnesses.I need to make the transition to another pattern - the spit of 8 loops.There is a small trick in this moment: to switch to another pattern looks nice, neat and minimally noticeable, first I need to adjust the number of loops a number of my future repeats. And rapport knitting bundles will be - 11 loops, but initially I was doing the calculation on the rapport 8 loops and loops will add the missing 3 uniformly in the course of work.. That is, it looks like this: total clean hinges on my spokes - 110. I need to understand how many bundles then fit in the cap - 110 divide by 8 (the number of loops in rapport) = 13.75. I rounded up to 13 repeats.Next, consider how many loops fit into my harness: my 13 repeats at 8 = 104 loops each loop.
Thus 110-104 = 6 loops currently on my needles unnecessary.
I turn on only the front loops of knitting! At the same time I loops evenly Bates 6 in this series of 31 (in my version I have every 17th and 18th loops along the front.So I get a number 31 crochet. All loops facial. On the spokes 104 loops. That's how the place looks from the inside of the pattern transfer.
I pass on the spokes №4,5
Number 32 - (2 persons 1lits of broaches the previous row, 2 facial, 1lits of broaches the previous row, 2 facial, PHI 2..) - Until the end of the series.
On the spokes 130 loops.
Adding all neatly and evenly.
Number 33 - (8 persons, 2 PHI) - Through a series of 
Number 34 - (8 persons, PHI 1, PHI 1 of the broach 1 PHI) - Through a series of  .On the spokes 143 loops.
Number 35 - (8 persons, 3 PHI) - to the end of the series
On the next row start cross loops and doing it in every 8 series:
Number 36 - (4 pet to remove additional spoke before work, 4 persons 4 persons with extra spokes, PHI 3....) - Before the end of the series37-43 number - (8 persons, 3 PHI) - to the end of the series
Repeat rows 36-43 2 more times - just 59 rows
Number 60 - (4 pet to remove additional spoke before work, 4 persons 4 persons with extra spokes, PHI 3....) - Before the end of the series
61-63 number - (8 persons, 3 PHI) - to the end of the series
Number 64 - (8 persons, 2 together PHI, PHI 1) - before the end of the series
65-67 rows - (8 persons, 2 PHI) - until the end
Number 68 - (4 pet to remove additional spoke before work, 1 persons 2 persons together, one individual, then loops with extra spokes -... 1 persons with 2 persons, 1 persons, PHI 2) - to the end of the series
69-71 rows - (6 persons, 2 PHI) - until the end
Number 72 - (6 persons, purl 2 together) - until the end
73-75 rows - (6 persons, 1 PHI) - until the end
Number 76 - (3 pet to remove additional spoke before work, 1 persons 2 persons together, then loops with extra spokes -... 2 persons together, 1 persons 1 PHI) - to the end of the series
77-79 rows - (4 persons, 1 PHI) - until the end
80 rows - (1 persons with 2 front, 1 persons 1 PHI) - until the end
81, 82 series - (3 persons, 1 PHI) - until the end
Number 83 - (1 persons with 2 persons, 1 PHI) - until the end
84, 85 series - (2 persons, 1 PHI) - until the end
Number 86 - (2 persons together, PHI 1) - until the end
Number 87 - (2 along the front) - until the end
The remaining 13 loops pull working yarn output end of the thread on the wrong side and fasten. My finished result which is contacted in the process of writing this treatise.This is the third related to cap me.  source

No comments :

Post a Comment